It is recommended that the target board power is supplied independently, especially for target boards with high power consumption and multiple power systems.If the “mass production" function is to be used, TPIN and TPOUT signal lines should also be connected.Connect signal lines (including GND) for corresponding interfaces of the ISP programmer with the target board.Search chip part numbers in the ISP programming software to view operation hint.The programming operation steps are as follows: User can erase, program, verify and read content of SPI EEPROM and Flash memory devices. The Serial Peripheral Interface (SPI) programmer (Superpro IS01 or Gang ISP programmer SuperPro IS03) provides fast programming of any SPI memory device by controlling the SPI bus signals directly through a dedicated high-speed SPI interface on the programmer. SuperPro IS01 Programmer supports high-speed programming of SPI compatible serial EEPROMs and Flash memory devices.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |